Jeff Garzik wrote:
> Attached below is a message I just sent to someone else who is having
> the same problem as you. Would it be possible for you to try the stuff
> I suggest in the message as well?
> Subject: Re: No IRQ known for interrupt pin A of device 00:0f.0
> Date: Sat, 28 Oct 2000 15:38:49 -0400
> From: Jeff Garzik <firstname.lastname@example.org>
> Organization: MandrakeSoft
> To: Burton Windle <email@example.com>
> CC: firstname.lastname@example.org, Linus Torvalds <email@example.com>,
> References: <Pine.LNX.firstname.lastname@example.org>
> Ok, the problem is that you have an interrupt router table for your Ali
> 1533, but no interrupt router entry for your IDE device. That's why
> pci_enable_device is failing.
> Would you mind testing two kernel patches for me? Both of these changes
> should be attempted separately in 2.4.0-test10-pre6, and -without-
> Andre's change.
> The first change attempts to build an interrupt router entry for you, if
> none is available. I am most interested if this works.
> The second change simply ignores any pci_enable_device error returns,
> and assumes that the IDE subsystem will pick up the pieces.
> Remember, do not apply both of these changes at the same time...
The second patch (the one ignoring errors) doesn't seem to change
anything (except not giving the warning IIRC)
Also, dump_pirq and lspci -vv output didn't change.
The first says the following at boot:
PCI: PCI BIOS revision 2.10 entry at 0xf0560, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 0: assuming transparent
PCI: Using IRQ router ALI [10b9/1533] at 00:07.0
PCI: Found IRQ 14 for device 00:0f.0
dump_pirq output remains the same.
The lspci -vv output does change with the second patch:
00:0f.0 IDE interface: Acer Laboratories Inc. M5229 (rev c1) (prog-if
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 2 min, 4 max, 32 set
- Interrupt: pin A routed to IRQ 0
+ Interrupt: pin A routed to IRQ 14
Region 4: I/O ports at d000
More info on request.
-- Linux 2.4.0-test10-pre6-test1 #1 Sat Oct 28 23:04:32 CEST 2000 - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to email@example.com Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Tue Oct 31 2000 - 21:00:24 EST